Pressing
Pressing Trigger Practice: Limited Touch Build-Up
Recognise pressing triggers
Pressing
Defending
Transition
Pressing Trigger Practice: Limited Touch Build-Up is a 18-minute pressing drill for 8-18 players, suitable for Under 11 to Adults at intermediate, advanced level. You need balls, cones, bibs. Below you will find the objective, the set-up, how to run it, coaching points, common mistakes, progressions, regressions and variations.
Back to drill libraryPressing
Defending
Transition
Skill Practice
Intermediate
Advanced
Full Squad
Minimal Equipment
Youth Friendly
Adult Suitable
Speed of Play
Playing Out From The Back
Possession
Duration
18 min
Players
8-18
Pitch size
Half pitch
Ability levels
Intermediate / Advanced
Pitch diagram
Pressing Trigger Practice: Limited Touch Build-Up — Marked area · Half pitch
Step 1 of 4Keeper starts play; the pressing team presses on the trigger — a back pass, heavy touch or pass to a wide player.
- 1. Keeper starts play; the pressing team presses on the trigger — a back pass, heavy touch or pass to a wide player.
- 2. Pressing team scores by winning the ball in the trap zone.
- 3. Ten build-ups then swap.
- 4. Maximum three touches in your own half, unlimited once you pass the halfway line.
- Cones mark the area
- Dashed lines = zones / thirds
- Ball
- Solid arrow = pass, thick = shot, dashed = run / dribble
Objectives
- -Recognise pressing triggers
- -Press as a unit not as individuals
- -Force play into pressing traps
Setup
- 1Build-up team of five plus a keeper in their own third.
- 2Pressing unit of five with cones marking the trap zones.
- 3Balls with the keeper.
Coaching instructions
- 1Keeper starts play; the pressing team presses on the trigger — a back pass, heavy touch or pass to a wide player.
- 2Pressing team scores by winning the ball in the trap zone.
- 3Ten build-ups then swap.
- 4Maximum three touches in your own half, unlimited once you pass the halfway line.
Coaching points
- -First presser curves their run to block the switch
- -Press when the ball travels, not before
- -Squeeze the whole unit up together
- -Support angles must be early and open
- -Break the press with a quick two-pass combination
Common mistakes
- -Pressing alone and getting bypassed
- -Straight run allowing the switch
- -Unit not squeezing behind the presser